Starter Triangles for Making Chevron Panels (Red & Lime)
Creating chevron panels on any vehicle is relatively easy. You first find dead center, mark it with a line from top to bottom, and then apply a triangle with 45 degree angled sides to the center at the bottom. After that you simply apply 6" alternating material in red and lime and then trim.
On this page we sell fluorescent lime and red precut starter triangles cut from Orafol/Reflexite V98 material which is the same material we use for all of our rolls and shapes on this site. To use them you simply peel off the backing, apply and press on with a soft cloth or rubber squeegee. Our red and lime triangles measure 5.5" tall and about 11" wide at the base. The angles are exactly 45 degrees to meet NFPA 1901 standards. Along with the triangle you would need to purchase 6" V98 Chevron Striping in fluorescent lime and red. With these items you would have all you need to create vivid, reflective chevrons on your vehicles or trailers. You can also combine our starter triangle with our 6" diagonals on this site to create 6" tall chevrons on bumpers or tailgates.
Shipping is FREE on this item. When ordered with other items on this site, such as 6" chevron striping rolls, you will pay only the shipping on the other item.
Our starter triangles are available in red and fluorescent lime. They are priced at $10 each with no additional shipping. You can make your quantity and color choice below using the drop down menus. (they match our V98 chevron striping rolls on this site exactly)